Jim Carter's Old Chevy Trucks - Classic Chevy & GMC Truck Parts for all of your restoration needs! 1000's of parts in stocks now!

Posts Tagged ‘breathe’

Original Engines Must Breathe

Thursday, February 11th, 2010

Before the modern Positive Crankcase Ventilating System (PCV) most automotive engines breathed externally and removed their excess products of combustion into the atmosphere. It was a standard of the industry!

The lower end of the engine (below the pistons) had an attached draft tube that extended outside and below the block. It released blow-by from worn piston rings and other pollutants created from the crankshaft turning in hot motor oil.

The upper end of the overhead valve engine also must breathe. On early Chevrolet and GMC inline six cylinder engines, the venting is usually in the valve cover through factory slots. When an add-oil cap exists on this cover, it seals tight. It does no breathing.

On 1955-62 Chevrolet 235 six cylinders the valve cover slots were illuminated. It is assumed badly worn engines at high RPM leaked oil at these slots. The venting requirement was now moved to the oil cap. These redesigned caps have two features. They cover the add oil hole and vent the upper end of the engine. Their disadvantage is their internal filter can clog with oil vapors and dirt from a badly worn engine. This type venting cap must be kept clean!

The following photos show venting methods on early Chevrolet and GMC engines. Note the oil and breathing cap on the later six cylinder Chevrolet engines.

original engine 1

1937 through 1953 216 sealed oil cap (above)

original engine 2

216 valve cover vent slot (above)

original engine 3

1954 Chevrlot Vents (above)

original engine 4

1955-1962 non vented cover (above)

original engine 5

1955-1962 vented oil cap (above)

original engine 6

1963-1972… 230 and 250 with PVC system (above)