Jim Carter's Old Chevy Trucks - Classic Chevy & GMC Truck Parts for all of your restoration needs! 1000's of parts in stocks now!

Posts Tagged ‘kit’

1939-1946 Electric Wiper Motor

Thursday, February 11th, 2010

electric wiper motor 1

Even if you prefer an original vacuum wiper motor for these years rebuildable cores have become very rare and most New Old Stock units are just not obtainable. Even new ones have their lubrication dry after 70 years.

For those that won’t except a slow moving or non-working used vacuum unit, an alternative does exist. New electric motors are now on the market in both 6 and 12 volt styles. The above photo shows a new unit before installation.

You will no longer need the original inside wiper cover plate with the indention. Replace it with the included non-indented style which gives a smooth finish.

The electric wires can be run inside the windshield post to a switch of your choice under the dash.

These kits can be obtained from Jim Carter Truck Parts at 1-800-842-1913.

Seat Cover Kits

Thursday, February 11th, 2010

Our seat cover kits are produced with an emphasis on originality. The materials are top quality for many year’s service. Seams, ribbing, etc., are based on original seats.

We recommend that installation be done by a professional upholstery company. However, if you wish to do it yourself, here are several important steps to follow:

1. Seat springs must be in original condition. No breaks, sags, etc.

2. Over springs, place one layer of burlap.

3. Over burlap, place two layers of cotton padding. Cotton must extend down over edges of outer springs.

4. Place vinyl cover over padding. Stretch evenly to eliminate wrinkles. Press special C shape clips at rear of springs to permanently hold cover in place.

5. If clips are put in place with pliers, cover the end with tape or equivalent to lessen chances to vinyl tears.

6. Wrinkles from storage will normally disappear in several days.