The early Chevrolet side mount bracket on the 1936 & older ½ ton and passenger car are almost identical. However, there is a part that is so different that this article needed to be posted.
The securing fastener that holds the tire clamp in place on top is totally different on the two vehicles. The passenger car uses a chrome plated die-cast T-handle that blends nicely with the chrome plated steel tire clamp. It’s an attractive pair that adds to the cars appearance. This T-handle is made to be turned by hand to begin the removal of the tire and wheel from the wheel well in the front fender.
On the other hand, the ½ ton (designed as a work vehicle) does it different. The tire clamp is painted black, not chromed, but most unique is the securing fastener. A long hexagon nut with internal threads holds all together on the ½ ton. It is designed to be turned with the vehicle’s lug nut wrench in the tool kit. It is so rare to see the correct hexagon nut on an early truck!
During the 2016 Vintage Chevrolet Club of America in Lake Tahoe, Nevada no early pickups had the correct fastener. They either had a car t-handle or hardware store nut.
Good news: Bids are currently being sent out by Jim Carter Truck Parts to have these special nuts made in quantities.
It seems the Chevrolet Motor Division, to save money, would have used the same side mount hardware in both the ½ ton and passenger car during the 1934-36 years. They did not! The attached photos show quite a difference in the cowl gasket and the horizontal support rod that is between the cowl and the long vertical support rod. Even during the Great Depression, they chose to make several changes in this area between the passenger cars and ½ tons.
Passenger Car T-handle and cowl attaching grommet
1/2 Ton Pickup Hexagon Nut and cowl attaching grommet
Hardware store nut if original is lost. (Yes, you can still use the lug wrench)