3000 Series Trucks
- Remove the bumper attaching bolts from the left hand front bumper bracket and discard.
- Place the left hand bumper guard in position and mount it to the bumper and bumper bracket using the lock-washers, flat washers and bolts furnished. Tighten securely.
- Mount and attach the right hand bumper guard following the procedure outlined in Steps 1 and 2 above.
- Remove the license plate and license plate bracket. Discard the bracket.
- Locate and mark the center of the bumper by measuring 16 inches from the inside edge of either bumper guard.
- Center the license plate with the mark made on the bumper. Using the horizontal centerlines of the two bottom holes in the license plate as a guide, mark the center of the holes to be drilled in the bumper by extending these horizontal centerlines 1-7/32 inch above the peak line of the bumper.
- At the locating marks just made, center punch and drill two 3/8 inch diameter holes through the bumper.
- Following the assembly sequence indicated in the illustration, attach the license plate to the bumper with the bolts, spacers, lock washers, and nuts provided.